Stray Plug In Engine bay | FerrariChat

Stray Plug In Engine bay

Discussion in '360/430' started by Kipper, Jul 24, 2010.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Kipper

    Kipper Karting

    May 1, 2010
    103
    Australia
    Full Name:
    Kipper
    #1 Kipper, Jul 24, 2010
    Last edited by a moderator: Sep 7, 2017
    Hi Members.

    On my 2005 360 spider there is a grey 2 pin square plug in the engine bay attached to the wiring lume under the RH throttle body and i cannot see where it should plug in. can any member help with advise as to what it is for please.

    Looking at the engine towards the front have placed it onto the chassis member for a better shot

    See attached picture, hopefully picture attaches, not quite sure how to do this?

    Thanks
    Kipper
    Image Unavailable, Please Login
     
  2. mrpcar

    mrpcar Formula 3

    May 27, 2007
    1,114
    Chino hills, CA
    Full Name:
    Robin
    That should connect to the vaccum solenoid right under the throttle body. There are some vaccum lines connected to the solenoid.
     
  3. Kipper

    Kipper Karting

    May 1, 2010
    103
    Australia
    Full Name:
    Kipper
    Thanks for your reply,

    The vacuum solenoid is located under the left side throttle body and has two similar plugs plugged into it 1 * Brown + 1* white.

    Under the right hand throttle body is where this plug comes from? any further guidance on this issue will be greatly appreciated.

    I dont know if there is a difference but my car is a Euro spec

    Thanks again

    Kipper
     
  4. Kipper

    Kipper Karting

    May 1, 2010
    103
    Australia
    Full Name:
    Kipper
    Hey Members,

    Anyone able to chime in on this thread?

    Kipper
     

Share This Page