Tail light bulb housing

Contact Verell Boaen at https://www.unobtainiumsupply.com -- he makes a reproduction part (on page 9 of the pdf catalog).

 

I 3D printed a repair piece out of carbon fiber for mine. I made some extra in case people needed them. They are easy to use, replace either one or both broken tabs. As you can see, they press inside the original design and you can simply trim off one tab if you want to keep one of yours, or use an xacto knife and trim the socket to fit both tabs. I made a special tool for die cutting the gaskets too.

I sell two repair rings and two die cut new gaskets for $25 shipped to you. I am in VA but could drop in the mail to you this afternoon.

Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login

 

This is the finished socket with one factory tab and one of my tabs. 1300 miles later, these hold up like the day I installed. Mine are just pressed in, but you could use a drop of super glue inside if you cared to.
Image Unavailable, Please Login