The FLAT Cavalino Badge | FerrariChat

The FLAT Cavalino Badge

Discussion in 'Ferrari Discussion (not model specific)' started by mwr4440, Nov 19, 2019.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. mwr4440

    mwr4440 Five Time F1 World Champ
    Rossa Subscribed

    Jun 8, 2007
    55,933
    Bavaria, The 'Other' Germany
    Full Name:
    Mark W.R.
    #1 mwr4440, Nov 19, 2019
    The FLAT Cavalino Badge.

    It came in 'Aluminum' and Flat Black (Annodized).


    Did Ferrari make and use it in a smaller version than the 120mm one used on the Testarossa?
     
  2. dave80gtsi

    dave80gtsi Formula 3
    Silver Subscribed

    Nov 3, 2003
    1,816
    Ohio
    Full Name:
    Dave Meredith
    #2 dave80gtsi, Nov 19, 2019
  3. mwr4440

    mwr4440 Five Time F1 World Champ
    Rossa Subscribed

    Jun 8, 2007
    55,933
    Bavaria, The 'Other' Germany
    Full Name:
    Mark W.R.
    #3 mwr4440, Nov 20, 2019
    Dave,

    That is exactly what I am asking about. :)

    Did they make a flat one in the smaller size like the sculpted chrome ones found on the back and sometimes grill of the 308 Series and other models?
     
  4. dave80gtsi

    dave80gtsi Formula 3
    Silver Subscribed

    Nov 3, 2003
    1,816
    Ohio
    Full Name:
    Dave Meredith
    #4 dave80gtsi, Nov 20, 2019
    Not that -I- personally have ever seen!

    Of course, you could always take a sculptured one ... and then find a belt sander ... !
     
  5. mwr4440

    mwr4440 Five Time F1 World Champ
    Rossa Subscribed

    Jun 8, 2007
    55,933
    Bavaria, The 'Other' Germany
    Full Name:
    Mark W.R.
    #5 mwr4440, Nov 20, 2019
    Know anyone with a CNC who might be able to make one?
     
  6. Rifledriver

    Rifledriver Three Time F1 World Champ

    Apr 29, 2004
    34,103
    Austin TX
    Full Name:
    Brian Crall
    #6 Rifledriver, Nov 20, 2019
    The flat large badge was only properly used to the best of my knowledge on the Boxers in silver and on the TR's through about 89 in black. A smaller one was used on the 328 front grill but is NLA. I had heard and in fact I loaned a spare I have to be reproduced but not sure if it ever came to fruition.
     
  7. Banzai!

    Banzai! Karting

    Mar 1, 2013
    71
    #7 Banzai!, Nov 20, 2019
    You would cut an item like this out of .09 / .12 (aluminum or stainless) flat stock, on a flat laser or waterjet. Might check with a local industrial heating and air conditioning shop who fabricates ductwork.
     

Share This Page