WHEEL SPACERS for F355

I have some 15mm 355 'specific' hill eng spacers on the rear only. They make a noticeable difference in handling for the better

 

15 mm on the rear only!!! what are you doing if you don t make the same on the front for having the right aligment...???

 

The spacers will not affect 'alignment'.

 

I have 15 mm spacers on each hub. (H&R)
First roll out I tested just 15 mm on the rear axle. Result: cornering was spoiled.
With another pair of 15 mm spacers for the front the 'cart feeling' was back again.
So I keep it this way.
In general, the handling turns from 'sedan' to 'cart'. (beeing aware the 355 is not a limosine at all)
If you play around a little bit, like I did, you can feel the huge difference between the 2 and 4 spacer setups.

have fun,

cinque

 

I was looking on Ricambi's site and its not really obvious which hill eng spacers are 355 specific ones, could it be these ones? "WS015DS 2 x 15mm Dual Spigot Spacers". Also are the stock 355 bolts long enough?

 

It's the normal WS015, but be sure to select the radio button for F355 style:
Image Unavailable, Please Login

 

Thanks Daniel

 

No the stock bolts are not long enough... .................... I may add 5-10mm in front if it will help handling........ though a few guys on here run spacers on the rear only.