window interior trim

any one know how to remove the interior leather trim by the rear window and sides were the seat belts are ?? i will re leather and door pannel also and were to start first step by step . will do the carpet also . thanks.

 

The leather trim? The lower piece is attached by 2 long studs with nuts that extend into the engine bay at about a 30 degree down angle It holds in the little oddly shaped end pieces. The other parts I have had out several times but do not remember exactly how they were attached but it was simple and intuitive.

The side panel covering the seat belt requires pulling off a few inches of door seal rubber, pulling off the small sort of flat piece about 2 x 4 that is glued on and exposing some screws. The piece under the side window comes with it. The long piece in front of the luggage shelf has a small screw at each end. Be careful, it bends very easily.

No one showed me. I figured it out. So can you. Its fragile. It was all hand made with foam and leather covering dead soft aluminum that bends very easily.

 

thanks this will help me.

 

I did a write up how to fix the mouse belts. Search for my name and you'll see a write up. Inside that thread shows photos of how to remove the trim pieces.

 

t

thanks for the info.