You'll want to see this Bendpak RJ-45 sliding bridge Jack!

How has the lift been? Any issues? Would you do anything different if you had to purchase again?

 

I have the Bendpak HD-9 and RJ-45 bridge jack but the bridge jack arms are not long enough to reach the Ferrari 360 lifting points, am I missing something very obvious on how to set this up? Thank you.

 

What is the absolute minimum ceiling garage height to be able to do this setup? Like the others have commented, NICE!

 

The height of each car that you would put under and on top of lift plus 8-10in is the absolute minimum - so the answer will vary based on car height

 

Mine has extending arms (about 16in. on each side) that slide out of the jack to reach the lift points.

 

I was also looking at getting a benpak but my garage ceiling height is only 106 inches. Wondering if I could get the 575 and the 328 to fit? I believe the post on the benpak are 100 inches tall and the 328 sits very low. And you also need clearance for the garage door and can alway mount a side garage motor.

 

Considering that a 328 is about 44.5 in high ( Called it 45) and a 550 is about 50.5 high ( call it 51) - added together put ramp and lock clearance

45 + 51 + 8 = 104 in

you are very very close - and that is without any lights on ceiling

Most garages are sloped so measure both front and back