| Author |
Message |
Bill V (Doc)
Member
Username: Doc
Post Number: 422
Registered: 9-2001
| | Posted on Monday, September 01, 2003 - 7:42 am: | |
Tony--check that thread which Barney rec'd. It may be the wires connections inside of the plastic stalk end or a broken piece of plastic from the end itself. I experienced a similar problem with mine as well and it turned out to be that the wires disconnected at the end of the shaft. I merely resoldered them and everything was back in order. However, other owners have noted that the plastic knob itself has been the culprit. Verell B--on the rec'd thread has been remanufacturing them for a reasonble price. |
Bill V (Doc)
Member
Username: Doc
Post Number: 421
Registered: 9-2001
| | Posted on Monday, September 01, 2003 - 7:37 am: | |
Tony--check that thread which Barney rec'd. It may be the wires connections inside of the plastic stalk end or a broken piece of plastic from the end itself. I experienced a similar problem with mine as well and it turned out to be that the wires disconnected at the end of the shaft. I merely resoldered them and everything was back in order. However, other owners have noted that the plastic knob itself has been the culprit. Verell B--on the rec'd thread has been remanufacturing them for a reasonble price. |
Barney Guzzo (Trinacria)
Member
Username: Trinacria
Post Number: 423
Registered: 8-2002
| | Posted on Sunday, August 31, 2003 - 11:40 pm: | |
Here is one:
http://www.ferrarichat.com/discus/messages/256120/240602.html |
Barney Guzzo (Trinacria)
Member
Username: Trinacria
Post Number: 422
Registered: 8-2002
| | Posted on Sunday, August 31, 2003 - 11:38 pm: | |
Hi Tony,
Look in the archives (use the "search" tool). There is a lot of discussion on this. It is likely a bad ground connection or a fuse box/relay problem. The stalks are almost impossible to find but someone was looking into making them. |
Tony Di Bernardo (Heritage58)
New member
Username: Heritage58
Post Number: 4
Registered: 5-2003
| | Posted on Sunday, August 31, 2003 - 11:23 pm: | |
of which I have none, but high beams are working, think its not a fuse or relay problem, is it possible I have a broken switch? The stalk raises the lifting motor but high beams do not stay lit unless I "hold" it in aft position.In other words, I can flick the high beams but not keep them on. Any experience in changing this part would be appreciated. Regards all. |