360 conversion | Page 21 | FerrariChat

360 conversion

Discussion in '360/430' started by RANDY6005, May 19, 2018.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

Page 21 of 76
  1. jcurry

    jcurry Two Time F1 World Champ Silver Subscribed

    Joined:
    Jan 16, 2012
    Messages:
    24,153
    Location:
    In the past
    Full Name:
    Jim
    fyi, the basic formulation of Simple Green can be corrosive to aluminum. Simple Green Extreme was created to correct that issue.
     
    jcurry, Jan 20, 2020
    #501
  2. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    Hey Jcurry thanks yes you are wright and it is approved aviation use witch say some thing about it as well .
     
    RANDY6005, Jan 20, 2020
    #502
  3. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    RANDY6005, Jan 20, 2020
    #503
    G. Pepper likes this.
  4. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    RANDY6005, Jan 20, 2020
    #504
    duck.co.za and Mel Spillman like this.
  5. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    Rear brake line bracket what a pain in the butt to remove !! The hex head screw that holds the ABS wire connection in place kept turning would not come lose.. And the brake line connection would not budge at all . I just had to stop and take off from it for a couple days . Best thing to do wend you get frustrated if you don not you tear up stuff . After time off and tried again it finely broke lose damn it !! For me to stop and take a brake is very hard to do I hate it.
     
    RANDY6005, Jan 20, 2020
    #505
    G. Pepper and Mel Spillman like this.
  6. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    RANDY6005, Jan 21, 2020
    #506
    G. Pepper and duck.co.za like this.
  7. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    Just weight CS titanium spring and the standard 360 steel spring 4.80 verses 2.70 deference 2.10 x 4 = 8.40 pounds all four spring, Have not weight the rear springs yet . I believe the rear springs are going to weight more so maybe even more weight saved switching to titanium
     
    RANDY6005, Jan 21, 2020
    #507
    G. Pepper likes this.
  8. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    RANDY6005, Jan 21, 2020
    #508
  9. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    RANDY6005, Jan 21, 2020
    #509
  10. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    All I had to do was pull apart clean and repaint and a new boot cover from Superformance 49.00 dollars looks like new again. Better than spending 684.00 for new one !
     
    RANDY6005, Jan 21, 2020
    #510
    G. Pepper and DARIES like this.
  11. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    RANDY6005, Jan 21, 2020
    #511
  12. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    rear bumper inter brackets
     
    RANDY6005, Jan 21, 2020
    #512
    one4torque and DARIES like this.
  13. one4torque

    one4torque F1 Veteran Silver Subscribed

    Joined:
    May 20, 2018
    Messages:
    5,782
    Location:
    Houston
    Full Name:
    One4torque
    Randy— fighting entropy like a BOSS!
     
    one4torque, Jan 21, 2020
    #513
    G. Pepper, kes7u and RANDY6005 like this.
  14. Mel Spillman

    Mel Spillman Formula Junior Silver Subscribed

    Joined:
    Nov 3, 2012
    Messages:
    733
    Location:
    Sugar Land, Tx
    Randy: What did you use on the bumper brackets? The look GREAT!
     
    Mel Spillman, Jan 21, 2020
    #514
  15. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    I first used Rustoleum rust remover to remove any rust and clean 3M scotch bright pad. Used etching epoxy primer and then used Eastwood three step golden cadmium paint.
     
    RANDY6005, Jan 21, 2020
    #515
    Mel Spillman likes this.
  16. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    RANDY6005, Jan 25, 2020
    #516
    02360spider likes this.
  17. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    That is the whole RH rear suspension parts and fastens , I am thinking about buying a parts tumbler to clean all the fasteners and small parts. The Ti spring just in from Italy Thursday should be here Monday hopefully start putting all back together soon .
     
    RANDY6005, Jan 25, 2020
    #517
    MCASEY likes this.
  18. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    OMG !! I have been studying how to set the ride height adjustments to CS specs this is going to be a nightmare a pain in the but and a slow process . You can not adjust the shocks springs with a spanner wrench, with the on wheels or rotors or calipers on . I am just guessing here you half to pulling off the rotors and wheels every time just check your height adjustment ? I know I can just leave the calipers off I putting new brake lines on anyway . The CS manual say to put sandbags 75 kg in drivers seat and passengers seat, In pounds 165.00 each, 15 kg is 33 pounds on LH rear RH mudguards .50 Liter of fuel 13 Gallons Damn it man !! ANY BETTER WAY ??
     
    RANDY6005, Jan 28, 2020
    #518
  19. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    RANDY6005, Jan 28, 2020
    #519
  20. G. Pepper

    G. Pepper Three Time F1 World Champ Rossa Subscribed

    Joined:
    Mar 15, 2012
    Messages:
    38,653
    Location:
    Texas/Colorado
    Full Name:
    George Pepper
    Bachelors know there is no such thing as entropy. Nothing is ever lost. Crap accumulates. :)
     
    G. Pepper, Jan 28, 2020
    #520
    EastMemphis and one4torque like this.
  21. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    RANDY6005, Jan 28, 2020
    #521
  22. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    These new CS Ti springs give me that same feeling wend you buy a new President Rolex in that wooded Rolex box .And then you get that funny feeling in your stomach :D
     
    RANDY6005, Jan 28, 2020
    #522
  23. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    RANDY6005, Jan 28, 2020
    #523
  24. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    They even have the brass tags placed around the springs with the part numbers etched in the brass very cool IMHO :cool:
     
    Last edited: Jan 28, 2020
    RANDY6005, Jan 28, 2020
    #524
  25. RANDY6005

    RANDY6005 Formula 3 Silver Subscribed

    Joined:
    Jan 9, 2017
    Messages:
    2,271
    Location:
    Jacksonville
    Full Name:
    RANDY
    crap !! windThrity again Damn it I forgot !! No posting on here wend it is that time !! Now it is to late to delete now !
     
    Last edited: Jan 28, 2020
    RANDY6005, Jan 28, 2020
    #525
Page 21 of 76

Share This Page