News

355 driver door slightly off

Discussion in 'Technical Q&A' started by beezerhound69, Feb 3, 2004.

  1. beezerhound69

    beezerhound69 Karting

    Feb 3, 2004
    136
    Suwanee
    Full Name:
    Tom
    Need some help, my 355's door is just a tad off (about 1/4 of an inch or less), yet it's enough to have a small gap where window and door meet the rubber seal. Any quick fixes or ways to adjust the door? Thanks.
     
  2. To remove this ad click here.

  3. BigHead

    BigHead Formula Junior

    Oct 31, 2003
    992
    Outside of Boston
    Full Name:
    Dennis
    the post where the door closes can be adjusted - it's located on the b-pillar, where the door grabs it when it is closed. Take an allen wrench to it. Loosen it up, and you can adjust the position of the post. Re-tighten, voila.

    Dunno if it can move a 1/4 inch, though... that's on the high side.

    Let us know.

    vty,

    --Dennis
     
  4. beezerhound69

    beezerhound69 Karting

    Feb 3, 2004
    136
    Suwanee
    Full Name:
    Tom
    So all I have to do is loosen it up , maybe position it inward a tad bit more and I'm in business? I saw the allen wrench hole on that peg, thanks for clearing it up. Take care,
    Tom
     
  5. beezerhound69

    beezerhound69 Karting

    Feb 3, 2004
    136
    Suwanee
    Full Name:
    Tom
    Thanks for the help Dennis. A 2 minute job that saved me a drive to Ferrari of Atlanta (even though they're great)
     

Share This Page