360/430 shock resistance | FerrariChat

360/430 shock resistance

Discussion in 'Technical Q&A' started by 24000rpm, Aug 5, 2018.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. 24000rpm

    24000rpm F1 Rookie

    Aug 31, 2012
    4,649
    China and California
    #1 24000rpm, Aug 5, 2018
    so i m going low on my car and replacing the OEM shocks. I wonder if I just measure the resistance and buy a resistor to connect to the connector. so that I can avoid the suspension warning?
     
  2. Motob

    Motob Formula 3
    Professional Ferrari Technician

    Nov 11, 2003
    2,239
    Frederick, Maryland
    Full Name:
    Brian Brown
    #2 Motob, Aug 5, 2018
    I would just disconnect the ECU for the system to keep the light off. It is under the dash on the drivers side, very easy to access.
     
    24000rpm likes this.
  3. 24000rpm

    24000rpm F1 Rookie

    Aug 31, 2012
    4,649
    China and California
    #3 24000rpm, Aug 5, 2018
    if this is a F430, will it affect the dial on the steering wheel? my dial won't change anything now.

     
  4. Keith360

    Keith360 Formula Junior

    Feb 6, 2015
    570
    Santa Barbara County
    Full Name:
    Keith Williams
    #4 Keith360, Aug 9, 2018
    I tried to fool the Suspension ECU using a 2.4 ohm resistor on each corner but still get a central warning of failure. I did this because I changed my coil-over struts to air struts. See post #52 on this thread.

    https://www.ferrarichat.com/forum/threads/air-suspension-on-360-spider.572885/page-3

    I’m going to try disconnecting the ECU mentioned above.
     

Share This Page