348 - Crank Position Sensor gap? | FerrariChat
Buy

348 Crank Position Sensor gap?

Discussion in '348/355' started by Ferrarium, Aug 2, 2019.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Ferrarium

    Ferrarium F1 Veteran
    Sponsor Rossa Subscribed

    Jul 28, 2018
    5,728
    Central NJ
    Full Name:
    Eric
    #1 Ferrarium, Aug 2, 2019
    I replaced mine but there were thin shims, on eon each. I actually dropped one and it did not get installed. I can't find in the WSM if there is a gap that is required that necessitates the shims. Sure hope not as the shime are nla and are real thin. I got the OEM sensors btw.
     
  2. m.stojanovic

    m.stojanovic F1 Rookie
    Silver Subscribed

    Dec 22, 2011
    3,211
    Serbia - Niš
    Full Name:
    Miroljub Stojanovic
    #2 m.stojanovic, Aug 2, 2019
    The gap should be 0.35 to 0.90 mm. With so wide range, the thin shims are obviously for the purpose of making the gaps of the two sensors the same. The new KIA sensors I recently installed had the gaps somewhere around 0.65 mm (middle of the range) without any shims. You should first check the gaps without shims and then, if required, add a shim or two to the sensor which has a slightly smaller gap than the other one, to make the gaps equal.
     
    ernie likes this.
  3. Ferrarium

    Ferrarium F1 Veteran
    Sponsor Rossa Subscribed

    Jul 28, 2018
    5,728
    Central NJ
    Full Name:
    Eric
    #3 Ferrarium, Aug 3, 2019
    Ok great I looked and looked but did not find in the WSM manual. Much obliged.
     
  4. m.stojanovic

    m.stojanovic F1 Rookie
    Silver Subscribed

    Dec 22, 2011
    3,211
    Serbia - Niš
    Full Name:
    Miroljub Stojanovic
    #4 m.stojanovic, Aug 3, 2019
    It's in the Section C - Ignition-Injection, pdf page 106 in my copy.
     
  5. Ferrarium

    Ferrarium F1 Veteran
    Sponsor Rossa Subscribed

    Jul 28, 2018
    5,728
    Central NJ
    Full Name:
    Eric
    #5 Ferrarium, Aug 3, 2019

Share This Page