News

exhaust hanger for middle section?

Discussion in '365 GT4 2+2/400/412' started by It's Ross, Jan 13, 2020.

  1. It's Ross

    It's Ross Formula 3

    Jul 30, 2007
    1,950
    Barrington, Ill. USA
    Full Name:
    Ross
    My parts book indicates PN 101999. Searching indicates this is a 70mm x 48mm ID piece. Sounds like the smaller one for the rear muffs. to me.
    Seems like asking for a lot of stretch from this little guy. Is this the correct part # and what other applications cross?
    thanks
     
  2. Rifledriver

    Rifledriver Two Time F1 World Champ

    Apr 29, 2004
    26,142
    Austin TX
    Full Name:
    Brian Crall
    101999 should be pretty large. I never had a great deal of difficulty installing them. It is the correct #. Where did you get it?
     
  3. It's Ross

    It's Ross Formula 3

    Jul 30, 2007
    1,950
    Barrington, Ill. USA
    Full Name:
    Ross
    From a Ferrari parts book. I indicates a size of 70mm x 48mm. Does this mean a typical round donut with an OD of 70mm and 48mm ID? Installed they are quite elongated as you know.
    Perhaps the dimension is for an oblong shaped piece with 70mm being the length and 48mm width? If so then ought to work.
    Do you have one of these on hand to look at?
    Thanks!
     
  4. Rifledriver

    Rifledriver Two Time F1 World Champ

    Apr 29, 2004
    26,142
    Austin TX
    Full Name:
    Brian Crall
    That sounds about right. If you look at the picture on Ricambis web site it looks correct.
     
  5. It's Ross

    It's Ross Formula 3

    Jul 30, 2007
    1,950
    Barrington, Ill. USA
    Full Name:
    Ross
    Thanks, hard to tell from the photo. Have you bought this # for hanging the center exh?
    $28 a piece? Yikes!
     
  6. Rifledriver

    Rifledriver Two Time F1 World Champ

    Apr 29, 2004
    26,142
    Austin TX
    Full Name:
    Brian Crall
    Yes but it has been a very long time.
     
  7. SouthJersey400i

    SouthJersey400i Formula 3

    Mar 14, 2007
    1,178
    Romulus, NY (Finger Lakes)
    Full Name:
    Ken Battle
    NAPA has two sizes of the round 'donuts', item nrs 35120 and 35352. I use one of these for my rear silencer as they are a bit smaller than the originals. They have a wide range of alternate types and sizes if you need a better fit.
    Ken
     
  8. jacques

    jacques Formula Junior

    May 23, 2006
    822
    Los Angeles/Florida
    I just this moment googled rubber exhaust donuts and amazon rubber exhaust donuts, and mercedes exhaust donuts, and found many sizes and varieties, and found dozens of them. Jq.
     
  9. SouthJersey400i

    SouthJersey400i Formula 3

    Mar 14, 2007
    1,178
    Romulus, NY (Finger Lakes)
    Full Name:
    Ken Battle
    Check out the tool on Amazon: OEMTOOLS 25543. This sure will help installing them!
    Ken
     

Share This Page