News

355 How to mount the front hold release lever ??

Discussion in '348/355' started by slracing, Jun 10, 2020.

  1. slracing

    slracing Formula Junior

    Jan 13, 2011
    410
    Europe
    Getting the lever mounted inside...with the cable already attached...next to impossible!! Does the cables need to be deattached in the front compartment? Clues appreciated;-)
     
  2. To remove this ad click here.

  3. slracing

    slracing Formula Junior

    Jan 13, 2011
    410
    Europe
  4. Ferrarium

    Ferrarium F1 Rookie
    Rossa Subscribed

    Jul 28, 2018
    3,005
    Central NJ
    Full Name:
    Eric
    Never done it buy my guess is that is exactly right, mount lever run cable, attach the release is typical for about any cable release system. Sam issue with the engine lid release. Provably need to remove the trunk liners for access as well.
     
  5. sevminasyan

    sevminasyan Formula 3
    Silver Subscribed

    Jun 24, 2008
    1,131
    Glendale, CA
    Full Name:
    Steve
    Loosen the retaining nuts on the front latches to be able to pull the cable back and once u install the release then use pliers to tighten the cable then tighten the nuts in the latch itself
     
    Beetle and slracing like this.
  6. 355OXO

    355OXO Karting

    Apr 16, 2006
    161
    UK
    Full Name:
    Simon
    If the cable is in situ already and you just want to replace the lever box. If it is the same as the rear boot release. you can hacksaw where the cable fits the release body to remove without taking cable out completely. do the same with the replacement and just refit the old cable. Hope this helps.
     
  7. To remove this ad click here.

  8. 355OXO

    355OXO Karting

    Apr 16, 2006
    161
    UK
    Full Name:
    Simon
  9. slracing

    slracing Formula Junior

    Jan 13, 2011
    410
    Europe
    Thanks for replying- will give it a shot one of these days
     

Share This Page