News

Looking for this part for 330GTC

Discussion in 'Vintage (thru 365 GTC4)' started by Oengus, Aug 1, 2020.

  1. Oengus

    Oengus F1 Veteran
    Rossa Subscribed

    Sep 29, 2004
    7,919
    Between timing belts or OH, SC, CO, CT
    Full Name:
    Chas
  2. enio45

    enio45 Formula Junior
    Rossa Subscribed

    May 16, 2004
    954
    Gilbert, AZ
    Full Name:
    Ed
    unless u find one - hard to do....i would make one out of aluminum.....assume u have the other one from the other side?
     
    turbo-joe likes this.
  3. Oengus

    Oengus F1 Veteran
    Rossa Subscribed

    Sep 29, 2004
    7,919
    Between timing belts or OH, SC, CO, CT
    Full Name:
    Chas
    yes I do have the other side
     
  4. enio45

    enio45 Formula Junior
    Rossa Subscribed

    May 16, 2004
    954
    Gilbert, AZ
    Full Name:
    Ed
    with a small flat blade screw driver it will pop out - it is made of plastic and chromed. Have one made from alum and u can
    have it either polished or chromed and your all set.
     
    TTR likes this.
  5. TTR

    TTR F1 Rookie
    Silver Subscribed

    Mar 29, 2007
    2,546
    Riverside, CA
    Full Name:
    Timo
    ... or stainless and polished.
    Also, if fabricating, might be a good idea to make two (or more) and place them on both sides to give matching appearance.
     
    enio45 likes this.
  6. enio45

    enio45 Formula Junior
    Rossa Subscribed

    May 16, 2004
    954
    Gilbert, AZ
    Full Name:
    Ed
    yes , good point!
     
  7. Oengus

    Oengus F1 Veteran
    Rossa Subscribed

    Sep 29, 2004
    7,919
    Between timing belts or OH, SC, CO, CT
    Full Name:
    Chas
    ok I’m on it....ty
     

Share This Page