430 Modern Ferrari 430 Tail Light - Possible GROUP BUY?

@nchhotu Nick, can you confirm if your reverse lights in these two pics are the same and it is just different lighting conditions (ie, day vs dark/night). In the one pic it's just a ring of white LED's and in the other it looks like the whole center lights up

https://www.ferrarichat.com/forum/posts/148829131/

https://www.ferrarichat.com/forum/posts/148831842/

Thank you!

John

 

I think its the light. The sun directly hits my front garage. Reverse is way brighter than stock.

 

Thank you Nick

In direct sunlight, the OEM reverse lights were definitely brighter than the LED's, but frankly neither would illuminate anything in daylight.

I'll try again later when it's dark

I actually have a light meter, see if I can run some tests.

 

Send pics

 

will do

 

Ok, cloudy skies set in so I took some shots in cloudy daylight as well as a dark garage

I used a typical photographer light meter

The LED lights are closer to the meter than oem since they are outside the car, so results are skewed in their slightly in their favor

Accessory switch on, engine not running, I don't know if this matters but comparably, should be same

Also took a shot with the hazards on to compare blinkers, seems OEM are equal or significantly better in all cases except right at the bulb

Reading at the reverse light (light emitted)

Reading at the taillight (light emitted)

Side to side comparison



Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login

 

Blinker (couldn't really measure with this device)

Garage door in dark garage (light received)

The 14 is the LED's

Also brand new interstate MTZ-34R installed last month

Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login

 

Awesome comparison, John! Did you have an LED upgrade like from Scud Ing Swiss on your OEM lights or were they the standard incandescent bulbs?

What are your impressions overall? Happy camper?

 

Funny you should ask Joe

I purchased the Scuding upgrade as I felt the lights needed something, but had not yet installed and then this came along, so the comparison is against OEM.

So to compare the two (Scuding upgrade to this), looks like it's

OEM look/style, not the greatest posts structurally (albeit can be shored up), super bright, incredibly well made high quality LED components (having them in hand)

Vs

Seemingly well made (no field testing yet), very well installed with 4 install points and metal post bracket, and a completely modern look, brightness more or less at OEM.

Unfortunately didn't get to test the brake light brightness, no one else home. This is the most important test, will see if I can test later.

So I am a happy camper with these, they look amazing and at night they will get the job done same as OEM. No less functionality and significant improvements in features imho.

I want to test the brake lights to make sure they are at least as bright as OEM, will do that later.

I would have liked a brighter reverse light.

Byron is this possible at this point? A brighter reverse light?

 

That's where a brick comes into play lol

I know my Scud Ing Swiss LED upgrade is incredibly bright over OEM. Glad to see these are at least as bright as OEM. All these nice pictures have me thinking

 

I considered that and tried a couple things, but the brake pedal actually requires some pretty active force and then I didn't want to mess around with anything too heavy so skipped it.

I know, from what I've seen and read the Scuding Swiss are extremely bright, and with OEM taillights, that's a great solution.

Since these are full LED with rings, and LED blinkers, they need to 'glow' or they don't look as cool (again, imho), too bright at night would actually distort the glow, so these probably are about where they should be and I expect will look totally awesome in the dark. Once I get them all in, will shoot some nice pics.

we're wearing you down.....

 

So its 14 v 56 on the reverse lights against the door?

 

I think we should also understand that these are LED and is more direct lighting compared to the oem ....which scatter the light more.

 

yes, 14 v 56 on the amount of light that makes it to the door a couple feet away at the center of the beam

you can see looking at the shot of the door, this is true what Flea says is true, the LED is definitely a more focused area, the incandescent basically just floods.

LED is also whiter light

that said, the OEM does illuminate more of the door based on the pic

they're different lights for sure, but I would say that if you were backing up against say some tall bushes, you're gonna get more light from the OEM's than you would from the LED's

you can see the side by side pics. basically, these lights are not brighter than OEM, they basically keep up. when you take everything into account though, they are definitely a very desirable solution for the F430 taillights.

maybe @ByronKong can do something about the reverse brightness, we'll see what he says

 

You are of course correct Tommy on the Scuding design, thank you for 'illuminating' that . There is no comparison between the two in terms of brightness achieved, the Scuding upgrade is a massive brightness increase over OEM.

And I suspect you are also correct that more LED's on the PBE lights, or even brightening them will probably not significantly increase received light.

Think it is safe to say at this point that the PB Engineering replacements are a very different looking taillight replacement and the Scuding upgrade is an intense brightness increase for existing lights.

So we still get the modern coolness factor, but not a brightness level upgrade.

I do not think this diminishes the PBE's in any way, at no point was there a claim that they were brighter (not that I recall seeing anyway).

 

It's not that we can't do brighter, we just have to balance a lot of factors. For example, the life of led, because the same area of the circuit board to add too much led will lead to heat dissipation problem. In addition, because our lamp is a smoke face, it also reduces the brightness of the lamp. The brightness could have been increased if we had done a transparent look, but I prefer the smoke face as it is now


从我的 iPhone 发送，使用 FerrariChat

 

Thank you Byron for the additional information. That all makes perfect sense.

 

Ok, so,.... had a chance to get the left side installed.

Pardon the partial update but I gotta say, DAMN, I am really, really psyched and wanted to share. They are BEYOND GORGEOUS! I can't believe how great they look! I was gonna take pics but phone pics do not do them justice, hopefully I can get some DSLR shots soon. You literally can't stop looking at them when they are on.

Not only do they look simply amazing, but they install extremely well. With the 4 posts, I was able to get them adjusted in the opening down to the millimeter. I really like a clean install. Before, my taillight gaps were all over the place, now I've got 4-5mm on both sides and the top, they are perfectly aligned.

And they are so SOLID, no movement at all. You feel like you could pull the car with them.

Some suggestions on the install which made it go really well:

Ordered 6mm stainless nylon flanged lock nuts to maximize adjustment ability and ensure nothing moves when done
https://a.co/d/gqiDV1h

Ordered EPDM washers for adjusting depth, this greatly allowed for positioning, by tightening down, you can move them by the millimeter
https://a.co/d/aa4ZZED

Tools that came in handy, stubby ratchets, and my tite-wrench (not used often, but great when it works out)

More to come, this is damn exciting!

To your earlier question @GogglesPisano , VERY HAPPY camper!

 

Great write up John. Looking forward to pics on the car. If I hadn’t bought the Scud Ing Swiss (which I’m really happy with) I would be sold on these.

That ratchet extension in your last pic would have come in handy when I was changing my taillights out (3 times total). On my birthday list now.

 

I have to agree with Bryon. I rather have reliability and longevity with the LEDs. I honestly don't need the reverse light to be crazy bright. It's fine the way it is. Brightness of the stop and signal light looks great!

I can't agree with John more with how these look on the car. I'm very pleased with the outcome! Thanks Byron!

....looking forward to John's update!

 

Been looking at my other cars, agree, not a big deal.

 

amazing write up, John. I think the reviews have convinced me. I missed the group buy but Byron is giving me a fair price. It’s what I get for waiting.

 

Thank you Joe

I can't wait to take them out!

 

Looking forward to your pictures mate.

Not fitted mine yet, been so busy, but yours especially in the grey should look amazing!